Silverback cutting outside toolpath

Looking for some suggestions as to why my silverback running easel is doing this. I was cutting out a charcruterie board using a file that i have used successfully a few times before. it was in the middle of cutting the hole at the end of the handle when it just took off in a straight line towards the left side of the machine. it also told me the cut was complete.

I dont have an exact answer to your question, but rather things to consider, and similar experiances uses easel for carves. One make sure probe thickness is inputed correctly still, as well as safe travel heights.

Also, i had noticed with easel, that sometimes crazy things happen. Not sure why.