Silverback 1x1m

I am trying to find out what size table I should build to support my new 1x1m Silverback. Any suggestions would be deeply appreciated.

1 Like

It really all depends if you want extra space on top to place a laptop and the controller box on the same surface or if you want a smaller top and to place the power supply elsewhere(below or on the side) and an articulating stand for the laptop, i have 15" of extra table top space to the left side of my cnc table where i set my laptop and sit off yo the side, doing pc stuff while the machine runs, rather than sitting in the front and being transfixed by the carve itself resulting in no other work gettig done, because im positive that would occur if
The estop is also over near where i sit off to that one side…

1 Like

My first 3d in my sikverback.

2 Likes