When using the 6060 with a laser module can the maximum speed for the X and Y axis be set higher than 2000 mm/min? $110 and $111 > 2000? I wasn’t sure what was causing the 2000 mm/min limit.
You could raise the values if you wanted, but with the lead screw design it is slower than a belt design. I wouldn’t raise them too high.
Thanks Shawn. I figured the screwdrives would be quite a bit slower than the belt. Also there’s quite a bit of inertia from the spindle mount. I’ll raise it up a couple hundred millimeters at a time and see how it behaves.