Laser Power switching from constant power to dynamic setting in GBRL program

I tried to switch my laser power in GBRL from constant to dynamic and it gave me an error and said my laser was not configured for that? Is there something I need to do when I down loaded the program or a setting somewhere I need to change?

Thanks

No, this is a message that just comes up in lasergrbl, your laser is capaple of dynamic power.

So what do you do to enable it

Its enabled. From what i understand.

The issue is caused by the fact that the controller doesn’t report to the software that it is EXACTLY “grbl v1.1f” or similar, so it isn’t recognizing that capacity.

Turns this into just a nuisance error, unfortunately.