GRBL settings for the 6550-PRO

Looking for the GRBL settings for the 6550-PRO.
Thanks, Duane

See defaults below.

Blank lines are not used; as those config values refer to multiple axis machines, which is a capability of GRBL, but not used in this application.

$0=10 (Step pulse time)
$1=100 (Step idle delay)
$2=0 (Step pulse invert)
$3=0 (Step direction invert)
$4=0 (Invert step enable pin)
$5=1 (Invert limit pins)
$6=0 (Invert probe pin)
$10=1 (Status report options)
$11=0.010 (Junction deviation)
$12=0.002 (Arc tolerance)
$13=0 (Report in inches)
$20=0 (Soft limits enable)
$21=1 (Hard limits enable)
$22=1 (Homing cycle enable)
$23=3 (Homing direction invert)
$24=300.000 (Homing locate feed rate)
$25=3000.000 (Homing search seek rate)
$26=250.000 (Homing switch debounce delay)
$27=1.000 (Homing switch pull-off distance)
$30=1000.000 (Maximum spindle speed)
$31=0.000 (Minimum spindle speed)
$32=1 (Laser-mode enable)
$37=1 ()
$100=80.000 (X-axis travel resolution)
$101=80.000 (Y-axis travel resolution)
$102=80.000 (Z-axis travel resolution)
$103=100.000 ()
$104=100.000 ()
$105=100.000 ()
$110=8000.000 (X-axis maximum rate)
$111=8000.000 (Y-axis maximum rate)
$112=8000.000 (Z-axis maximum rate)
$113=1000.000 ()
$114=1000.000 ()
$115=1000.000 ()
$120=500.000 (X-axis acceleration)
$121=500.000 (Y-axis acceleration)
$122=500.000 (Z-axis acceleration)
$123=200.000 ()
$124=200.000 ()
$125=200.000 ()
$130=510.000 (X-axis maximum travel)
$131=460.000 (Y-axis maximum travel)
$132=80.000 (Z-axis maximum travel)
$133=300.000 ()
$134=300.000 ()
$135=300.000 ()

Thank you, Jim. I just installed a new controller on my 6550-PRO and having some trouble with it so I wanted to check to see if anything in the settings needs to be changed or has changed.