Accessory Command (M7, M8, M9 Command)


has someone managed to use an accessory (such as a relay to a vaccum) with the silverback controller? Would be nice to be able to control the accessory through the M7,M8, M9 commands.

I wonder if a pin on the Offline Controller connector would allow me to connect one.

Has anyone tried it or have experience to share?

Sorry for the delay - missed the post…

The offline controller connector is only active for communication to the chipset, there is not a direct connection to any output points (there are unused pins).

There are a couple of unused ports on the board inside, but I would have to go grab one and see what they are designated as - assuming they are properly labeled.