Good morning,
We had purchased the 6550 kit end of 2021 with the 40W laser. Was working fine until one day it was no longer fire. We decided to purchase the new 80W with the 32bit board to attach to our machine, just received it yesterday.
We also have the z-axis, air assist and black track for the wires that we had purchased with our 40W. The issue this morning is that we want to assemble the board and the laser but it seems like the wires for the z-axis will not be long enough and the screws are short, therefore, not fit on the new laser. I sent a message to Yora and awaiting a response but wanted to see here if someone had run into a similar situation.
Thank you in advance for your help.
Annick